Manual toggle presses with round ram
EP series

Toggle presses only produce their rated force at the end of the stroke, the bottom dead centre (BDC). In doing so, the high working pressure of the press is achieved using the toggle mechanism with a relatively low effort (approximately 150 N) from the user.

Toggle presses are therefore used where the full force of the press is only required over a short distance at the end of the working stroke, e.g. in assembling, punching, rivetting, stamping, gluing etc.

All Baltec toggle presses are recognized by the following quality features:

• factory-set bottom dead centre (BDC)
• simple adjustment of the height of the press head using a threaded spindle
• hardened and ground ram
• long, honed and therefore highly precise ram guide
• ground press table
  

EP - the ERGOPRESS ® series the concept of a modern, ergonomic manual toggle press for manual workstations in industrial series production.

The ERGOPRESS ® models represent a logical development of the manual press-in technology.

ERGOPRESS ® hand lever
switched over for left-handed
operation

ERGOPRESS ® hand lever 360 ° variably adjustable hand lever the basic version of the press can be rapidly adapted for left or right-handed operation just by switching over the toggle lever the laterally offset lever ensures unobstructed view of the work area

This means higher output through optimum destressing: with ERGOPRESS ®, cramped and incorrect posture during operation is a thing of the past. This reduces absenteeism, increases the motivation of personnel, makes work easier and lowers production costs.